POWE50102
EN
Copyright © 2018 VARO
P a g e
|
8
www.varo.com
9.3
Clamping the work piece
Make sure the work piece can’t be catapulted. The clamp (5) is the most perfect gadget to
avoid this.
▪
Press the work piece against the fence (6) and between the clamp
▪
Tighten the clamp (5) clockwise to secure the work piece.
9.4
Horizontal mitre angle
▪
Loosen the lock knob for mitre angle (14) and turn the saw table tip to left or right until the
pointer point at the desired angle on the angle gauge for mitre angle (7), tighten the lock
knob (14).
9.5
Adjusting of the cutting angle
The angle gauges are set at the factory, but we recommend that for precision work you check
and if necessary calibrating them as follows.
▪
90° bevel angle: Lock the upper arm in its lowered position by the release knob (18), and
set bevel and mitre angles to 0° on the angle gauges. Place a try square at the side of the
saw blade and table fence (6), if the mitre angle is not 90° bevel angle, achieve the right
angle by loosen the lock button for the angle adjustment (14) and the 2 fence screws,
adjust the alignment of the fence in relation to the saw blade end re-tighten the 2 fence
screws.
9.6
Vertical bevel angle (Fig. 1)
The vertical bevel angle can be set in the range of 0° to 45°. The vertical bevel scale shows
the currently set in degrees.
▪
Loosen the locking lever (21), if tightened.
▪
Swing the tool arm with the handle to the required angle.
▪
Tighten the locking lever (21).
▪
Place a protractor at the side of the saw blade and table, if the angle is not 45° bevel
angle. Adjusting the height of the adjustment screw until the bevel angle is the correct
angle. Finally tighten the nut and check the angle once more.
9.7
Slide lock adjustment
▪
To unlock and lock the slide bar (
23
), turn the slide bar lock knob (
24
) counterclockwise or
clockwise
9.8
Switching ON / OFF
For your safety use both hands to switch the power tool on and off.
▪
Connect the power tool to the power supply.
▪
Pull the on/off switch (11) in the direction of the handle. The saw blade rotates as long as
you keep the switch engaged.
▪
When you want to turn off the machine, you have to release the on/off switch (11).
9.9
Laser (25)
Your machine is equipped with a laser.
The laser helps you to cut the work pieces at the correct place.
9.10
Dust bag
To attach the dust bag (17), fit it onto the dust extraction adapter. When the dust bag is about
half full, remove the dust bag from the tool and empty it.
