POW3065..
EN
Copyright © 2012 VARO
P a g e
|
7
§
Never completely discharge the rechargeable battery.
§
You will have long service life if the rechargeable battery is regularly loaded and then
recharged.
8.2
Operating instructions :
8.2.1
Setting the torque :
§
Your cordless drill is fitted with a 24-level torque setting (4) with a slip coupling. This
enables you to select the perfect setting for the job in hand.
§
Start work with a low torque setting.
§
When you insert the first screw you will find out how much torque is required.
§
If the torque provided by the current setting is inadequate, set it to the next level.
§
If the screw can be inserted as intended down to the surface of the workpiece, the
drill/screwdriver is set to the correct torque.
8.2.2
Keyless chuck :
§
To insert drill bits : set the drill to turn clockwise, insert the bit and hold the front ring on the
chuck. Start the drill at a slow speed.
§
To remove drill bits : set the drill to turn anti-clockwise and hold front ring on the chuck.
Start the drill at a low speed.
8.2.3
Electronic speed control :
§
By pressing the ON/OFF switch (1) you can control the speed of the drill from 0 to
maximum speed.
8.2.4
Direction of rotation :
§
Set speed setting to .
§
Set direction of rotation slider to clockwise rotation.
§
Position bit and slowly increase speed and drilling pressure.
8.2.5
Screwing :
§
Torque setting to 1-24.
§
Set the direction of rotating slider to clockwise.
§
For removing screws set it to anti-clockwise.
§
Use the appropriate flathead or crosshead bit.
8.2.6
To switch over from 1st gear to 2nd gear :
You can use a higher or lower speed depending on the gear that you have selected.
§
1st gear : low speed (screw driving).
§
2nd gear : high speed (drilling).
§
To avoid damaging the gear, always wait until the machine has reached a standstill before
you move the gear switch.