POW3065..
EN
Copyright © 2012 VARO
P a g e
|
6
§
Only use the specified charger unit for charging the battery. Do not charge any other
batteries with this charger unit. The mains adapter should only be used together with this
charger unit and the appropriate battery pack of the POW306532.
§
The charger unit should only be used in a dry environment at temperatures between 10°C
and 40°C.
§
Do not use the charger unit if it is damaged.
§
Only have the charger unit and the battery repaired by an authorised after-sales service
department.
§
Avoid short-circuiting the battery. Ensure that the battery terminals do not come into
contact with metal objects.
§
Do not keep the battery in places where the temperature can reach 50°C and more, for
example in a car parked in the sun.
§
Do not attempt to burn the battery.
§
Never try to open the battery.
§
If battery fluid (a 25 to 30% solution of potassium hydroxide), comes into contact with the
skin, immediately rinse the skin with plenty of water. Neutralise the solution with a mild
acid, such as lemon juice or vinegar. If the solution comes into contact with eyes, rinse
them with running water for at least ten minutes, and then consult your doctor.
8 OPERATION
8.1
Charging the battery :
(For the charger unit and battery capacities, see Technical data)
8.1.1
Before start-up :
§
First check the LCD (11) for battery capacity before use.
§
press LCD knob (10) before using.
§
Only use the drill with above 80% capacity.
§
Please recharge the battery below 60 %.
§
When you have used the battery intensively, you should let it cool down +/- 10 minutes
before recharging.
§
Keep rechargeable battery away from heat and fire.
§
Don't store the device close to heat sources or in direct sunlight. Protect it against
temperatures above 50°C.
8.1.2
Charging :
§
Charge the battery before you use the cordless drill for the first time.
§
Slide the direction switch (2) to the centre setting before you take the battery out of the
machine. This will ensure that the drill will not start accidentally.
§
Press the side snap fastening (7) and remove the battery (6).
§
Place the power supply plug in a 230V/50Hz socket.
§
Place the battery into the charger station. The incorrect position has a block - do NOT use
force.
§
In order to fully charge the battery cell, the charging time in the first three charge cycles
must be over 12 hours. After that, charging time will be only 3-5 hours (POW30650 /
POW306502 / POW306532). POW306552 = 1 hour. Once the battery is fully charged you
have to pull the plug from the socket, the battery does not automatically stop charging.
§
When charger is put to the mains supply, the green light will go ON, when the battery is
connected to the charger, the red light is also ON, when the battery is fully charged, both
lights will remain ON.
§
(POW306552 = When charger is put to the mains supply, the green light will go ON, when
the battery is connected to the charger, the green light is flickering, when the battery is
fully charged, the red light will go ON).
§
A full battery will not discharge, even if it is not being used.