How to use
s
1.
Clean the Motor unit and accessories before using. Refer to the section “How to
clean and maintain” immediately following this section.
2.
Place the Base of the Motor unit on a flat, dry and heat-resistant surface.
The Blender
3.
Place the Blender Jug with the Blender Blade assembly on top of the Motor unit
and screw it clockwise. Ensure that the Blender Jug has locked tightly in place.
4.
Wash the fruit/s and/or vegetables, then peel and cut into no larger than 1
inch
(2.5 cm) cubes. Add liquids such as water or milk, then place the cut fruits or
vegetables into the Blender Jug with the, topped off with yoghurt or ice cream if
desired. The total volume should NOT exceed 400
ml.
Note: For optimal performance, place the ingredients in the Blender Jug
according to the following sequence:
Liquids, fresh ingredients, frozen fruits, yoghurt, ice cream.
5.
Attach the Lid to the Blender Jug firmly.
6.
Plug the power cable into the wall socket and switch ON. Press the ON/OFF
Switch to blend until the desired consistency is achieved.
DO NOT operate the appliance for more than 1 minute without interruption.
Let the appliance rest for 2 minutes between processing cycles. After 3
processing cycles, allow an interval of 15 minutes to let the appliance cool
down before the next use, so as to prolong its service life. DO NOT allow
the product to idle while in operation.
7.
On the completion of blending, release the ON/OFF Switch, switch off the wall
switch and unplug the power cable.
8.
Wait for the blades to stop turning and unscrew the Blender Jug with the Blender
Blade assembly anti-clockwise from the Motor unit and detach.
9.
Remove the Lid from the Blender Jug and the contents may be poured out
