3/8
Key Name
Description
End back tacking
setting key
Switch during all end tacking type when press the
key is lit.(No tacking, once tacking,
double tacking, 4 repeat tacking). Show
is end back tacking interface,default range
1~F corresponds to the 1~15 pin.
W sewing
The system enter to W sewing mode when press the
key is lit. Show
is w
sewing interface,default range 1~F corresponds to the 1~15 pin.
Multi-section
constant-stitch
sewing
The system enter to multi-section constant-stitch sewing mode when press the
key is lit.
Show
is multi-section constant-stitch sewing interface, Use
key and
key to
adjustment Increasing and decreasing value. Default maximum range 15.
Soft start setting key
Soft start at the first seam is enabled (the
key is lit ) or disabled.
Stop position key
Select up/down stop position.Press
key is lit that is called up stop position. Press
key
again ,the lights went out that is called down stop position.
Trimming cycle
selection
Enable or disable the trimming cycle.the
key is lit when the automatic trimming.
Presser foot lifting
Mode
Switch during all presser foot lifting mode when pressing the
key is lit. (No lifting, lifting
after trimming cycle only, lifting at machine stop only, lifting at machine stop and after
trimming cycle both).
One-shot-sewing
selection
In constant-stitch sewing
：
a. Press the
key is lit, automatic performed number of stitches of
every section.
b. Press
key again ,the lights went out to finish rest the sections until it finish pattern.
Custom function key
Special function according to the custom requirement.
Up keys
Adjust the values in plus state. In addition, when the parameter is set, it can be used as the
key to adjust the corresponding parameters.
Down keys
Adjust the values minus state.
In addition, when the parameter is set, it can be used as the
key to adjust the corresponding parameters.
3 System Parameters Setting List
3.1 Technician Mode
NO. Range
Default
Description
1
、
Long press
P
key can modify the technical parameter table;
2、
The digital tube display
，
It is required to enter password to the technical parameter. Press the corresponding
key and
key to change the password value;
3
、
Press
P
key, If the password is correct, that is to enter the technical parameters set mode,show P1 0 0.Press
key, the current
parameter value is displayed;