23
Maintenance (cont’d)
Change engine oil
While engine is still hot, drain all engine oil out from the crankcase.
1.)
Remove the oil filler cap and drain plug to drain oil
2.)
Install the drain plug and tighten it securely.
3.)
Refill with the recommended oil and check the oil level.
208cc (.6 Liters/20 ounces)
4.)
Install the oil filler cap.
Note: Please dispose of used motor oil in a manner that is compatible with the environment. Do not throw in trash
or pour on the ground.
Air Filter
A dirty air cleaner may block air flowing into the carburetor. To keep the carburetor in good working condition,
service the air filter periodically. If operating engine in a dusty environment, it should be cleaned frequently.
1.)
Remove the wing nut and the air cleaner cover. Remove the
element and separate them. Carefully check element for holes or
tears and replace if damaged.
2.)
Clean element with household detergents and warm water, rinse
thoroughly. Allow element to dry completely.
3.)
Soak element in clean engine oil and squeeze out the excess oil.
Engine will smoke during initial start- up if too much oil is left on
foam.
4.)
Reinstall the filter element and air cleaner housing.
CAUTION
Never run the engine without an air cleaner. Dirt
and dust may enter the engine and cause it to
ware.
