Powerhorse M1577110E, Owner'S Manual

Page: 29 / 62

29
Bad
Bad
Bad
Exposed wire
mesh due to wear
Water dripping or
spraying, or localized
moisture
Good
Bad
Inspect Spray System
Inspect spray system for damage and leaks before
each use.
Do not start pressure washer until all needed repairs
have been completed.
WARNING: High Pressure Fluid
Injection Hazard
High pressure fluid discharge from leaks (even
pin-sized) or ruptured components can pierce
skin and inject fluid into the body. Injection injury
can result in blood poisoning and/or severe
tissue damage leading to infection, gangrene,
and possibly amputation.

Never use a finger or skin to check for
leaks.

Never operate machine with damaged or
missing hoses/parts.

Never attempt to repair a high-pressure
hose or component – Always replace it
with a part that is rated at or above the
pressure rating of this machine.
1) Check hoses, fittings, wand, trigger gun and
connections for signs of wear, cracks, looseness, or
leaks. Replace as required.
2) Check and clean the nozzle orifice.
Inspect Fuel System
Inspect the engine fuel system and check for leaks
before each use.
Do not start pressure washer until all needed repairs
have been completed.
WARNING: Filter Disposal
Gasoline fuel is highly explosive and fuel leaks
can result in fire or explosions. You can be
burned and seriously injured if the fuel system is
not properly hooked up or there is a fuel leak
when you start the engine.
Inspect the entire fuel system. Look for:

signs of leaks or deterioration,

chafed or spongy fuel hose,

loose connections,

loose or missing fuel hose clamps,

damaged fuel tank, or

defective gasoline shut-off valve.
Check Tire Pressure
Check and refill tire pressure before each use .
1) Remove air cap on tire.
2) Check tire pressure.
3) If needed, fill tire to 30 psi (2.07 bar). Do not
overinflate.
Replace air cap.
Perform Engine Maintenance
-As specified in the “Engine Manual” Section.
Engine maintenance items include:
1. Changing oil and oil filter
2. Air filter check/replacement
3. Spark plug cleaning and replacement
4. Fuel filter check/replacement
Inspecting and cleaning muffler (and spark arrestor if
equipped)