Installation/Initial Set-Up
19
Never place the generator immediately adjacent to a building or other
structure – allow at least 7 feet clearance.
Do not run the generator in close proximity to other heat-generating
equipment, such as another generator. The combined heat that is generated
may raise air temperature in the immediate area and there will not be
adequate cooling ventilation.
Do not allow debris to accumulate and block airflow.
Do not operate with a tarp, blanket, or cover surrounding the generator.
No wet
conditions
Choose a location where the generator will NOT be exposed to rain, snow,
or direct sunlight.
Exposure to water can cause electric shock.
You
may
operate the generator under an outdoor, canopy-like structure of
heat-resistant material that is open on all sides. Make sure that all parts of
canopy are at least 7 feet from exhaust, and allow for adequate clearance
above generator so that heat does not build up.
Hot exhaust
clearance
The exhaust gas from your generator is extremely hot and can cause
combustible materials to catch on fire.
Make sure your generator’s exhaust system is at least 7 feet from all
combustible materials and buildings/structures.
Equip the engine with a spark arrestor if the generator will be used near any
ignitable forest, brush, or grassy land. (See the “Specifications” section of
this manual to determine if your generator is already equipped.) Make sure
you comply with applicable local, state, and federal codes.
Keep a fire extinguisher rated “ABC” nearby. Keep it properly charged and
be familiar with its use.
Away from
dust/dirt
Do not use the generator in extremely dusty or dirty conditions.
Excessive
dust and dirt can cause premature failure of the machine.
Hearing
protection
Generators can produce noise levels of up to 95 dB in close proximity,
which can be dangerous to human hearing with prolonged exposure.
Hearing protection may be required for persons working within 15-20 feet of
the running generator for an extended period of time.
WARNING:
Never attempt to attach ductwork to the muffler system to lower noise
levels. This could cause hot air deflection, heat build-up, and increased
exhaust back-pressure, resulting in possible exhaust leakage or damage
to the generator.
Summary of Contents for 1661132
Page 2: ...Hazard Signal Word Definitions 2...
Page 48: ...1661132 Engine Parts Rev B 48...
Page 51: ...1661132 Generator Parts Rev B 51...
Page 54: ...Wheel Kit Assembly 54...
