Powerfix Profi PLBS 2 A1, Translation Of The Original Instructions

Page: 20 / 74

GB
│
IE
│ 17 ■ PLBS 2 A1
♦ Place the outer tab of the cover back on the
centring rib of the cover.
♦ Swing the cover back until the release buttons
click audibly into place on both sides.
♦ Ensure that the cover is firmly in place on the
drill dust collector. This is the only way to pre-
vent dust escaping.
Appliance suction function
♦ After you have aligned the laser or put the drill
dust collector/drill against the wall, switch on
the vacuum pump at the switch .
♦ Push the appliance briefly firmly against the
wall. After a short time, the appliance will be
firmly sucked against the wall.
♦ Ensure that the seal of the appliance is fully
against the wall.
♦ Check that the appliance stays in place by
trying gently to pull it off or slide it across the
surface.
♦ Leave the vacuum pump switched on the whole
time you are working with the line laser and/or
the drill dust collector. Otherwise, the appliance
will not be able to maintain a sufficient vacuum
and the appliance could come off the wall.
♦ Do not use the appliance for overhead work.
♦ If the appliance does not remain on the wall,
it may be because the surface structure of the
wall is simply too rough, and the appliance is
unable to generate a sufficient vacuum. In this
case, you will need a second person to hold the
appliance in place.
♦ Ensure that the seal is not damaged or cut
by rough surfaces, edges or corners.
Detaching the appliance
♦ First, finish your work with the line laser and/
or the drill and then remove the drill from the
appliance.
♦ Hold the appliance firmly in place to prevent it
from falling down.
♦ Switch off the vacuum pump at the switch
and press the vacuum button .
♦ Remove the appliance from the surface.
♦ Use the protective cover to protect the appli-
ance and the seals .
Troubleshooting
–
The laser is not working
Battery is dead > replace battery.
–
Appliance does not grip onto the surface
Battery is dead or too weak > replace battery.
Seal is damaged > Hold the appliance by
hand.
Wall structure is too rough > Hold the appli-
ance by hand.