Powerfix Profi PLBS 2 A1, Translation Of The Original Instructions

Page: 19 / 74

■ 16 │
GB
│
IE
PLBS 2 A1
Getting started
■ After inserting the batteries, the appliance is
ready for use.
■ Remove the protective cover/wall bracket
from the appliance.
■ Fully grip the appliance with one or, ideally,
both hands. The appliance is suitable for either
hand.
Operation
CAUTION!
► Use the appliance only for its intended use.
► Check the appliance for damage before use.
Do not use the appliance if its operational
safety cannot be guaranteed.
Switching the line laser on and off
♦ To switch the line laser on and off, press the
ON/OFF switch .
■ To make the levels easier to read, these
are illuminated.
♦ Switch the laser off again by pressing the
ON/OFF switch .
Aligning the line laser
♦ Align the appliance using the horizontal and
vertical levels by changing the tilt angle of
the appliance. Centre the air bubble in one of
the levels between the two marking lines.
♦ For diagonal alignment of the laser, mark two
points in the desired alignment and line up the
laser with these markings.
♦ Switch on the vacuum pump (see section
Appliance suction function ).
♦ To use the line laser without the suction func-
tion, you can release it from the mount by pulling
it in a horizontal direction.
♦ Replace the line laser on the guide and push it
in the direction of the battery compartment
until it clicks audibly into place.
Using the drill dust collector
♦ Mark the spot on the wall where you want to
drill the holes.
♦ Push the loaded drill through the opening on
the protective plate until it comes out of the
other side of the seal .
♦ Put the tip of the drill bit onto the marking.
♦ Hold the drill vertically to the wall.
♦ Push the drill dust collector up against the
wall so that the seals lie up against the
wall.
NOTE
► To ensure that the drill dust collector collects
the dusts optimally, it should always be
aligned vertically.
♦ Switch on the vacuum pump (see section
Appliance suction function ).
♦ Hold the drill firmly in both hands and follow the
manufacturer's operating and safety instructions.
♦ Use only suitable drills up to a max. 10 mm in
diameter.
♦ Wear your personal protective equipment
(safety goggles)!
♦ Pull the drill out of the drill dust collector
before you switch off the vacuum pump.
Emptying the drill dust collector
♦ Point the drill dust collector downwards.
Press the release buttons together on both
sides between your thumb and index finger and
swing the cover of the drill dust collector
upwards.
♦ Empty the drill dust collector .