V4.0
20 in. Misting Wall/Floor Fan
8908519
Visit www.princessauto.com for more information
7
IDENTIFICATION KEY
A Fan head
B Bracket Knob (2)
C Wall Bracket
D Power Cord
E Base Plate
F
Legs (2)
G Plate Bolts and Nuts (3)
H Leg Bolt, Washer and Nut (4)
I
Misting Ring Kit (not shown)
ASSEMBLY & INSTALLATION
Dashed numbers in parenthesis (Fig. 1-1) refer to a specific point in an
illustration or image.
WALL MOUNT ASSEMBLY
NOTICE! It is the user's responsibility to be sure that the location and the
wall surface can handle the weight of this fan (14.6 lbs).
The hardware to mount the fan to a vertical surface is not included with the fan.
1. Use the wall bracket (C) as a template for marking the intended drill
holes on the mounting surface.
2. Drill holes through the mounting surface.
3. Drill completely through steel with a 9/32 in. drill bit at the pre
-
marked
locations. Attach the wall bracket (C) to the mounting surface with
1/4 in.
-
20 hex bolts, 1/4 in. flat washers, 1/4 in. lock washers and
1/4 in. hex nuts.
4. Mount the fan to a masonry surface with 1/4 in. expansion type bolts or
1/4 in. masonry lag screws with a shield that are designed to handle the
weight of this fan. Drill holes at pre
-
marked locations using an
appropriately sized drill bit as recommended for the fastener.
Fig. 1
