Installation
The following points must be respected when choosing a location for
the charger.
1.
The location must be dry, dust-free and indoors. The acceptable
temperature range for operation is 0°C to +40°C. A higher ambient
temperature will limit the current supply, see appendix A on page 6.
Caution: The charger is not waterproof. Keep the charger dry and
away from areas with high humidity in order to avoid the risk of
electrical shock and damage to the charger.
2. The equipment may be installed horizontally or vertically. The
horizontal position, however, is recommended with a height of 1
meter above floor level.
3. To ensure sufficient ventilation, leave a free space of at least 10 cm
around all sides of the charger. Do not cover the unit.
4. The charging process generates explosive hydrogen gas. Keep the
area well ventilated. Never use an open flame and avoid sparks
close to the battery and charger.
5. The floor and material below the charger must be fire-resistant.
Install the charger using the railed assembly plate (see figure). With
vertical mounting, place the vertical slide barrier downwards. Fasten
the assembly board to the wall using the mounting holes in the back
of the board. Next, place the charger in the assembly board by
inserting the rails at the bottom side of the charger, into the rail
guides. Finally, fasten the charger to the assembly board by using
the small screws on the side of the board. Fix the sticker (see
appendix C), if provided, to the topside of the charger. Plug the main
power cord into an earthed mains outlet.
3