background image

   

PowerChord Group Limited 

Registered in England & Wales No. 9303518 

Registered Office: 1 Blythe Road, London W14 0HG 

5725-5850 MHz 
Available 20 MHz channels 149,153,157,161,165,169 

Section in standard 

Transmit power (including 
antenna gain) e.i.r.p 

14 dBm  

EN 300 440 7.1.3  

Radar detection 

No 

N/A 

TPC 

No 

N/A 

LSB 

Yes 

EN 300 440 9 

Regulatory Notices: 

FCC ID: 

2AO3Y-PWR100154

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions:  (1)  This  device  may  not  cause  harmful  interference,  and  (2)  this  device  must 
accept any interference received, including interference that may cause undesired operation. 

This  equipment  has  been  tested  and  found  to  comply  with  the  limits  for  a  Class  B  digital 
device, pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable 
protection  against  harmful  interference  in  a  residential  installation.  This  equipment 
generates,  uses  and  can  radiate  radio  frequency  energy  and,  if  not  installed  and  used  in 
accordance with the instructions, may cause harmful interference to radio communications.  
However, there is no guarantee that interference will not occur in a particular installation.  If 
this equipment does cause harmful interference to radio or television reception, which can 
be determined by turning the equipment off and on, the user is encouraged to try to correct 
the interference by one of the following measures: 

Reorient or relocate the receiving antenna. 

Increase the separation between the equipment and receiver. 

Connect the equipment into an outlet on a circuit different from that 
to which the receiver is connected. 

Consult the dealer or an experienced radio/TV technician for help. 

FCC Caution: 

 

Any  changes  or  modifications  not  expressly  approved  by  the  party  responsible  for 
compliance could void the user's authority to operate this equipment. 

 

This  transmitter  must  not  be  co-located  or  operating  in  conjunction  with  any  other 
antenna or transmitter. 

Radiation Exposure Statement: 
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled 
environment. This equipment should be installed and operated with minimum distance 
20cm between the radiator & your body.

 

Summary of Contents for PEEX PWR-100154










Reviews: