CHARGING BATTERY PACK
CHARGE BATTERY PACK:
1. Make sure the trigger on the
Cordless Driver is in the “OFF”
position and remove the battery
pack from the Cordless Driver.
2. Plug 120V AC adapter into house-
hold outlet and insert the adapter
plug inside the charging port on
the top of the battery pack. The red
LED on the top of the battery pack
turns on indicating battery being
charged.
3.
After 3-5 hours of charging,
the empty battery becomes
fully charged and Red LED
turns off and Green LED turns
on.
Remove the battery pack from charger and reattach battery pack onto Cordless Driver,
making certain latches fasten securely. Cordless Driver will not operate properly if the battery
pack is not seated properly.
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your Cordless Driver continuously, the batteries in your battery pack will
become hot. You should let a hot battery pack cool down for approximately 30 minutes
before attempting to recharge.
This will occur when continuous use of your Cordless
Drill causes the battery pack to become hot.
It does not occur under normal
circumstances.
BATTERY LED INDICATIONS
Solid Red: Battery Charging
Solid Green: Battery Charged/Full
Blinking Red: Battery Hot
12
BATTERY
PACK
LED’s
120V AC
ADAPTER/CHARGER
CHARGING PORT
