Example - landing flaps:
Both landing flaps are to be controlled using one channel; this is channel 5 at
the transmitter. Assign
DIRECT 5
to any two outputs, e.g.
Q
and
R
. Now plug in
one landing flap, and set it up accurately at the transmitter. The other landing
flap is connected and adjusted later, i.e. during the servo matching procedure.
The final point in the Basic Setup Assistant is to define the direction of gyro
effect, and the integral
iGyro
activates itself to allow this. By physically moving
the model you can check whether the gyro’s effect is in the correct direction;
reverse it if necessary.
Note:
if, for example, one elevator channel is used for both sides, the direction
of effect must be rechecked if you subsequently reverse that output in the servo
matching menu. The direction of effect can then be corrected manually using
the iGyro menu.
5. Servo matching
At this juncture you can reverse the landing flaps and elevators, and adjust the
servos’ centre and end-points if necessary.
If your model is fitted with more than one servo per control surface, this is the
time to fine-tune the servos to match each other, and connect the control
surface linkages.
6. Door Sequencer Assistant
Start the Assistant, carry out each step exactly as described on-screen, and
then connect the servos and / or valves one by one. As of Version 07 the
system incorporates a second front wheel door, which makes it possible to
complete the set-up procedure for the whole retract sequence in about ten
minutes.
If you also need to adjust the process times, we suggest that you visit our
Forum, where you will find a list of all tasks in the FAQ section. It is a very
simple matter to adjust the pause and running times for the doors manually.
7. Setting up the iGyro in flight
The final step is to adjust the gyro’s settings in flight. This is accomplished by
selecting the
TEST FLY ASSISTANT
, and adjusting all three axes while the
model is in the air. We recommend that you carry out several ‘dry runs’ on the
ground in order to familiarise yourself with the sequence of operations.
The
Royal SRS
is now fully set up, and we wish you great fun and success with
the system!
-05-
Summary of Contents for Royal SRS
Page 1: ...Quickstart Guide...
