97
Maintenance and Service
5.8
Squeegee
1 Squeegee holding attachment
2 Wing nuts
3 Connection nozzle
4 Sealing strip (rear)
5 Support strip (rear)
6 Clamping rail (rear)
7 Support roller
8 Knurled nut
The squeegee is also equipped with
front sealing and support strips and
clamping rail (Fig. 35).
5.8.1 Cleaning the squeegee
Inspect the squeegee when raised daily
and clean as necessary.
5.8.2 Disassembling the squeegee
1. Insert the key in the key switch and
turn the key switch on.
2. Lower the squeegee: Press the but-
ton for the squeegee and suction tur-
bine so that the green control lamp
lights up.
Fig. 34
3. Switch off the key switch and remove
the key.
4. Open the rear doors.
5. Pull the suction hose from the con-
nection nozzle (Fig. 34/3) of the
squeegee.
6. Loosen the wing nuts (Fig. 34/2) on
the holding attachment.
7. Pull the squeegee away to the rear
under the holding attachment.
8. Insert the key in the key switch and
turn the key switch on.
9. The squeegee is raised automatical-
ly.
10.Close the rear doors.
2
3
4
1
5
6
7
8
