PB50 Low Profile Manual
Original instructions
2019
4
hand or againstyour body is unstable and may lead to loss of control.
2.
Do not force tool. Use the correct tool for your application.
Thecorrect tool will do the job better and safer at the
rate for which it isdesigned.
3.
Do not use tool if switch does not turn it on or off.
Any tool thatcannot be controlled with the switch is dangerous
and must be repaired.
4.
Disconnect the plug from the power source before makinganyadjustments, changing accessories, or storing the
tool.
Suchpreventive safety measures reduce the risk of starting the toolaccidentally.
5.
Store idle tools out of reach of children and other untrainedpersons.
Tools are dangerous in the hands of untrained
users.
6.
Maintain tools with care. Keep cutting tools sharp and clean.
Properly maintained tools, with sharp cutting edges are
less likely to bindand are easier to control.
7.
Check for misalignment or binding of moving parts, breakage ofparts, and any other condition that may affect the
tools operation. Ifdamaged, have the tool serviced before using.
Many accidents arecaused by poorly maintained
tools.
8.
Use only accessories that are recommended by the manufacturerfor your model.
Accessories that may be suitable
for one tool, maybecome hazardous when used on another tool.
Service
1.
Tool service must be performed only by qualified repair personnel.
Service or maintenance performed by unqualified
personnel could result in arisk of injury.
2.
When servicing a tool, use only identical replacement parts. Followinstructions in the Maintenance section of this
manual.
Use ofunauthorized parts or failure to follow Maintenance Instructions may createa risk of electric shock or
injury.
WARNING!
Always use safety chain.
Mounting can release.
3) INFORMATION PLATE SYMBOLS
1
2
3
4
1.
Refer to the user manual for operational and safety issues with regard to this machine.
2.
Dispose of the machine and electrical components correctly.
3.
Eye protection must be worn when operating the machine.
4.
Ear defenders must be worn when operating the machine.
