5. X-OVER or MODE Switch for FULL/HPF/LPF
Activates the built in electronic crossover network. Works in conjunction with the HPF and LPF adjustable
controls.
6. LPF (Low Pass Filter) Control
This control is continuously adjustable from 40Hz through 250Hz at 12dB per octave.
7. BASS Control
This equalization circuit is used to enhance the low frequency response of the vehicle’s interior. With up to
18dB of boost centered at 40Hz, the BASS EQ can be adjusted to meet your own personal taste.
8. REMOTE
This is the connector port for the optional Remote Bass Boost Control. Now the amplifiers secondary gain cir-
cuit can be adjusted from the driver’s seat. (See your local PowerBass dealer and ask for model ASA-BASS
sold separately.)
9. POWER Indicator
The GREEN L.E.D. lights up when the power is on.
10. STATUS Indicator
This L.E.D. turns RED constantly or flashes when the built-in protection circuitry is activated. This indicates a
problem with the system in relation to the amplifier (see Troubleshooting Tips).
11. SPEAKER Output Terminals
As shown in the wiring diagrams, be sure to observe speaker polarity through the system and speaker im-
pedance. This specially tooled solderlessterminal is designed to accommodate up to 10 gauge speaker wire.
12. FUSES
For convenience most PowerBass AutoSound amplifiers utilize common automotive ATC type fuses. For
continued protection in the event that a fuse blows, replace the fuse only with the same value. (See speficifi-
cation tables)
13. BATT+ (Power Input Connection)
This terminal is the main power input for the amplifier and must be connected directly to the positive (+)
terminal of the car battery. (see Power Cable Selection Chart for recommended wire gauge for each model).
7
Summary of Contents for ASA 1100.5x
Page 22: ......
