INSTALLATION PRECAUTIONS
NOTE: Proceed only if you are a qualified installer, otherwise; see your Authorized PowerBass
Dealer to professionally install this amplifier. Always wear protective eyewear when using
tools.
•
Turn off all stereo and other electrical devices before you begin.
•
Disconnect the negative (-) lead from your vehicles battery.
•
Locate all fuel lines, brake lines, oil lines, and electrical cables when planning the install.
•
Make sure there is at least 2-inches (5 cm) around the air vents on the amplifier.
•
When connecting ground points, make sure all paint is carefully scrapped away from the auto body
and contact is make with bare metal.
•
Use a utility knife to trim away fabric from hole locations before drilling or cutting.
•
When running power cables through sheet metal, be sure to use grommets to properly insulate the
metal edges from the wire insulation.
•
If possible, use tubing through grommets.
To keep your PowerBass Autosound amplifier running at top performance, choosing the proper location
is of utmost importance. For this reason the amplifier should be mounted in a location which will allow
air to circulate freely. A clearance of at least 2-inches (5 cm) to all sides of the amplifier is necessary
not only for proper cooling, but also for gaining access to the inputs and other variable controls. Be sure
that the power and signal cable connections can enter and leave the amplifier in a straight line to avoid
the risk of kinked wires causing malfunction.
Fig.1 Mounting Amplifier
MOUNTING THE AMPLIFIER
Summary of Contents for ASA 1100.5x
Page 22: ......
