There are two basic mounting options for your PowerBass Line Output Converter. One is to mount the unit
using the supplied brackets as shown in Fig 1. Once attached, you may use the brackets as a template and
mark the two screw locations with a felt tip pen. Use caution to make sure there are no objects behind the
installation surface that may become damaged during drilling.
The other option is to use a large cable or wire tie and secure it behind the dash by wrapping it around the
chassis of the unit. Make sure the Line Output Converter is secure and do not let the unit hang by the wiring.
Doing so may cause the wiring plugs to become loose and even disconnected over time due to road vibrations
which will cause the Line Output Converter to stop working.
It is highly recommended to complete the wiring of the Line Output Converter and set the GAIN adjustment
prior to mounting the unit.
SETUP ADJUSTMENT
GAIN Controls (Front and Rear)
Set the GAIN to increase the amount of signal coming from the Line Output Converter to your amplifier(s). Start
with the control at the MIN position (completely counter clock wise). Adjust the GAIN control clockwise until
the orange CLIP indicator begins to flicker, then back off slightly to cut distortion and operate at optimum gain.
Fig.1
Fig.2
MOUNTING THE LINE OUTPUT CONVERTER
