Finally feed the tweeter’s speaker wire from the
tweeter assembly
through the basket and
magnet. Thread the pole piece to the basket (where the phase bullet was removed) by turning
clockwise taking care not to damage the midrange voice coil assembly.
Once fully assembled, route the tweeter’s speaker wire in the channel on the back of the
magnet and down through the heat sink fin. Attach a new magnet label over the wire and the
magnet to help keep the wire in place. This will prevent the speaker wire from interfering with
any mechanisms behind the door panel.
The conversion from Component to Coaxial is now complete! It will still be necessary to use
the crossover network just the same as with the component speaker. Please refer to the Com-
ponent Set Crossover Installation and Wiring section of this manual for proper mounting and
wiring instructions.
NOTE:
The midrange will wire to the crossover network in the same manner regardless if
used as a component or coaxial.
Tweeter
Assembly
Connect speaker wire
from tweeter to the
crossover network
