2
1
Battery
Compartment
Dash
• Position the dash on the vehicle body.
• Make sure the motor harness connector wire is through
the groove in the dash.
• Insert a #10 x
1
/
2
" screw through each of the two corner
dash tabs nearest to the passenger compartment
.
• Insert a #10 x 1" screw through the two dash tabs
nearest to the battery compartment
.
• Insert a #10 x 1" screw into the hole in the center of the
dash, near the battery retainer clip
.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Battery Clamp
3
9
• Locate the battery compartment door on the back of
the radio.
• Loosen the screw in the battery compartment door using
a Phillips screwdriver and lift to open.
• Insert three “AA” (LR6) alkaline batteries, as indicated in
the battery compartment.
• To replace the battery compartment door, fit the tabs
on the door into the slots on the radio. Lower to close.
Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Note:
• Do not mix old and new batteries.
• Do not mix different types of batteries:
alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Remove batteries during long periods of non-use.
Always remove exhausted batteries from this product.
Battery leakage and corrosion can damage this
product. Dispose of exhausted batteries safely.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type, as
recommended above, are to be used.
• If removable rechargeable batteries are used, they are
only to be charged under adult supervision.
• Rechargeable batteries are to be removed from this
product before they are charged.
• Battery chargers used with toys must be examined
regularly for damage to the cord, plug, enclosure and
other parts. In the event that such damage is found, the
toy must not be used with the battery charger until the
damage has been repaired.
Battery
Compartment
Battery
Compartment
Door
Assembly
4
1.5V x 3
“AA” (LR6)
2
Battery
Clamp Unit
• Insert two #10 x 1" screws through the holes in the
battery clamp unit and into the pegs in the dash.
Motor
Harness
Connector
Wire
74340a-0921.qrk 12/8/00 12:50 PM Page 9
