© 2020 Power-Tronics, Inc.
16
Bench Check Procedures
1.
Wire the XC14 as shown in the figure below.
2.
Connect up one 120 volt 50 to 150 watt incandescent light bulb to the F+ and F- Terminals.
3.
Install a temporary jumper wire between terminals X and Y.
4.
Turn the internal voltage adjustment (blue potentiometer) fully Counter-Clockwise (Left) before beginning
the testing procedures below.
5.
Input 120-240VAC fused at no more than 5A into the XC14.
The test light should be
OFF
.
6.
Slowly
turn the internal voltage adjustment Clockwise (Right) until the light glows.
The test light
should light to
HALF
Brightness.
NOTE: It may take several turns of the adjustment screw
before the lights illuminate!
7.
Slowly turn the internal voltage adjustment Counter-Clockwise (Left) until the lights go dark.
The test
light should be
OFF
.
NOTE: It may take several turns of the adjustment screw before the lights
go dark!
8.
Turn off AC power and disconnect the XC14 from your AC power source.
9.
If you were able to successfully perform all of these tests, the XC14 is good.
120V 50-150W
Incandescent
Fuse Replacement Information:
XC14 Main:
Rating: 20A @ 250VAC
Qty: 1
PTI Part #
5R3-628
Littelfuse Part #
0314020.MXP
Jumper
120-240VAC
Fused @ 5A
