15
© SPX
Form No. 1000573
Rev. 0 February 8, 2012
Adding Hydraulic Fluid to the Reservoir or Bladder
1. Retract the cylinder(s) devices.
2. Disconnect the power supply.
3. Clean the entire area around the filler plug.
4. Remove the filler plug, and install a clean funnel with a filter.
5.
Use only Power Team hydraulic fluid 47 cSt @ 38°C (215 SUS @ 100°
F).
General Maintenance continued
Sound Reduction - Electrically Powered Motor
The electrically powered hydraulic pump operates in the 90-95 dBA range. If further sound reduction is
desired, any of the following options will help reduce the sound level.
1. Install a pressure switch to automatically shut off the motor when maximum pressure is reached
(holding cycle).
2. Contact Power Team Hydraulic Technology technical support for products more suitable to your
application.
Hose Connections
CAUTION: To prevent personal injury from leaking hydraulic fluid, seal all hydraulic
connections with a high-quality, non-hardening, pipe thread sealant.
IMPORTANT: Sealant tape or non-hardening sealer tape can be used to seal hydraulic
connections if only one layer of tape is used. Apply tape carefully, two threads back, to
prevent it from being pinched by the coupler and broken off inside the system. Loose
pieces of sealant could travel through the system and obstruct the flow of fluid or cause
jamming of precision-fit parts.
Storage
Store the unit in a dry, well-protected area where it will not be exposed to corrosive vapors, dust, or
other harmful elements. If a unit has been stored for an extended period of time, it must be thoroughly
inspected before it is used.
Summary of Contents for P2102-ANCHOR
Page 2: ...SPX Form No 1000573 Rev 0 February 8 2012...
Page 22: ......
