7
A. Drive Control Handle
Located on the right side of the upper handle, the
Drive Control is used to engage and disengage
the drive wheels. Squeeze the Drive Control
handle against the upper handle to engage the
wheels; release to disengage.
B. Speed Control Lever
The Speed Control Lever is located in the center
of the panel and is used to set the drive speed
and direction of travel. It can be moved into any
of six positions.
C. Auger Control Handle
Located on the left side of the upper handle, the
Auger Control is used to engage and disengage
the augers. Squeeze the Auger Control to
engage the augers; release to disengage the
augers.
D. Chute Rotation Handle
To adjust snow discharge direction, rotate the
handle clockwise or counter-clockwise.
E. Engine
See the Engine Manual for engine operation
information.
F. Skid Shoe
Position the shoes based on the surface
conditions. Adjust upward for hard-packed snow.
Adjust downward when operating on gravel or
crushed rock surfaces.
G and H. Augers and Impeller
When engaged, the augers rotate to cut snow
and direct it into the impeller housing to be
discharged out the chute.
I. Snow/Ice Clean Out Tool
The chute Clean-out Tool is conveniently
fastened to the rear of the auger housing with a
mounting clip. It is used to clean the chute
assembly and chute opening when snow and ice
become lodged.
WARNING! Never use your hands to clear a
clogged chute assembly. Shut off engine and
remain behind handles until all moving parts
have stopped before unclogging.
J. Chute Assembly
The chute provides a discharge path for snow
being thrown. The chute is adjustable.
K. Chute Deflector Lever
The angle of the chute deflector controls the
discharge distance of the snow. Raising the
angle will increase the distance . Lowering the
angle will decrease the distance.
Shave Plate (not shown)
The Shave Plate maintains contact with
pavement as the snow thrower is propelled,
allowing snow close to pavement's surface to be
discharged.
BOX CONTENTS
Check to ensure all of the following items are
included:
• Snow Thrower (1)
• Chute Assembly (discharge chute, chute rotation
bar, gear assembly, lower chute crank rod and
hardware)
• Upper Chute Crank Rod and hardware
• Lower Handles (2 pieces and hardware)
• Wheel Assembly (2 pieces and retaining pins)
• Snow/Ice Clean Out Tool (1)
Located in Accessory Parts Bag:
• Skid Shoes (2 pieces and hardware)
• Speed Control Cable Clips (3)
• Oil Funnel (1)
• Spark Plug Wrench (1)
• Spare Auger Shear Pins (2)
• Operator's Manual (1)
• Engine Manual (1)
• Registration Card (1)
ASSEMBLY
Your Snow Thrower will require some assembly.
Please complete the following steps before using
your Snow Thrower. For easy assembly, we
recommend attaching the components in the
order listed in this manual.
Chute Assembly
1. Install the discharge chute onto the chute
flange on the housing. The chute only rests on
the flange.