Installation Instructions for Power Sentry Emergency Battery Packs
–QD MVOLT Series
Page 2
Battery Pack System Components
Figure 1
Components Description
Battery Pack
Housing
Lamp Selector Switch
(PS 1400 only)
Mounting Slots
Quick Disconnect
Wire Harness Plug
Test Switch / Pilot
Light (TS/PL)
Quick Disconnect
Battery Pack Power
Connector
TS/PL Mounting
Clip
TS/PL Label
TS/PL Connector
Charge Indicator
Sticker
Installation
Step 1
– Install Battery Pack
1. Turn off all external power to the luminaire
2. Inspect Battery Pack and make sure the TSPL
connector
is not
connected. If so, disconnect it
before installation of the Battery Pack.
3. Position the unit in the fixture wireway and fasten
securely through the Mounting Slots
. If
necessary, drill holes and mount with sheet metal
cutting screws (not provided)
4. Attach a flat wire tie holder as shown in Figure 2
5. Refer to the appropriate wiring diagram, Connect
unit to the ballast, lamp(s) and AC input power as
indicated in the wiring diagram.
6. Attach and fully engage the Quick Disconnect Wire
Harness Plug
into the Battery Pack Power
Connector
Inspect that the Wire Harness Plug
is squarely seated against the Battery Pack Power
Connector.
7. Insert a wire tie into the flat wire tie holder and pull
the wire tie tight as shown in Figure 3
8. Inspect that the Wire Harness Plug is still squarely
seated against the Battery Pack Power Connector.
Figure 2
Figure 3
Step 2
– Install Test Switch / Pilot Light
(TS/PL)
CAUTION
Fixture contains live wires during portions of the
installation. Use insulated tools and gloves.
1. Locate a suitable location for the TS/PL and cable
that is at least 1” from the fixture lamps and is
visible outside the fixture lens
2.
Drill or punch a ½” diameter hole in the fixture wall
or wireway cover
3. Insert one side of TS/PL
into the hole from the
inside of the fixture housing until it snaps in place.
4
Slide TS/PL Mounting Clip
firmly to lock and
secure the TS/PL assembly
5, Mark the TS/PL location on the fixture with the
TS/PL Label
.
6
Apply continuous AC power to the battery pack
7. Connect and fully engage the TS/PL Connector
to the battery pack. Insure the TS/PL Connector
latch is properly seated in the recess slot on the
battery pack housing
8. Verify the TS/PL light is on.
9. Close fixture housing and insure no possibility of
pinching any wire between housing channel and
cover.
