© Copyright 2010 Power Plate International
1.
Remove the two M8 screws (A) and slide out
the top bracket (B).
2.
Mount the top bracket (B) on the Powerplate
base with two M8 screws (C). Apply Loctite
243 on the screws before tightening them at
25Nm.
3.
Take out the two lower brackets (D) by
removing two M8 screws (E).
4.
Mount the two lower brackets (D) on the
Powerplate base with four M8 screws (F).
Apply Loctite 243 before tightening them at
25Nm.Make sure left and right is not swapped
and make sure the bracket is mount as on
above image and not upside down (round
metal bar should be on the top side)
5.
Make sure the M8 screws (G) on left and right
side of the proMotion are loose, but do not
take them out.
6.
Slide the promotion on the top bracket (B), and
push it strongly against the Powerplate.
7.
Connect the promotion to the lower brackets
(D) by screwing in the two M8 screws (E)
loosely, apply Loctite 243 on them, but do not
tighten them yet!
8.
Screw in two M8 screws with Loctite 243 on
the top (A) to fix the promotion on the top
bracket (B). Tighten them at 25Nm.
9.
Tighten two M8 screws (E) for the lower
brackets at 25Nm.
10.
Take out the two M8 screws (G) on the left and
right side of the promotion, apply Loctite 243
and tighten them at 25Nm.
Steps to follow for both left and right side
proMOTION Mounting Diagram
Power Plate Assembly
– pro
6
