Power One Aurora PVI-10.0-TL-OUTD, Installation And Configuration Manual

Page: 14 / 69

11 - en
en
-
english
photovoltaic inverters
procedure for assembling retaining clips and Wm connectors (Weidermüller connectors)
note: After assembly, the retaining clip cannot be removed.
note: Once the male connector has been fitted to the female connector equipped with the clip, they can only be
disconnected using the specific tool illustrated in the figure below.
multicontat WeideRmülleR
note: The disconnection tool for MC/WM connectors can be obtained from any Power-One products distributor.
Ensure that the integrated switch (versions –S and –FS) is in the OFF position or that the external switches
are open.
Connect the connectors that you previously crimped to the input connectors in the lower part of the
inverter, paying attention to the polarity.
lower part of pVi-3.0/3.6-tl-outd(-s) lower part of pVi-4.2-tl-outd(-s)
lower part of pVi-5000/6000-tl-outd lower part of pVi-10.0/12.5-tl-outd(-fs)
Insert the retaining clip as
shown in the figure.
fit the male connector
into the female connector.