10
1.
Operation manual
─ accompanying file. Please carefully
read the operation manual before operation and properly
keep the operation manual for future learning and
reference. The operation manual provides safety operation
skills and is necessary for the operator.
2.
Front baffle
─ installed between the handle and chain and
used to protect the hand of the operator from slipping off
the carrying handle and being injured. The front baffle can
also help to control the chain saw. The hand guard can also
help to activate the chain brake to stop the chain.
3.
Carrying handle (held by the left hand)
─ installed on
the front part of the engine shell and used for supporting.
4.
Rear handle (held by the right hand)
─ installed on the
rear part of the engine shell and used for supporting.
5.
Hand guard of rear handle
─ refer to the extension part
under the rear handle, which is used to protect the hand
from being injured by the chain broken or moving out of
the slot.
6.
Right side plate
─ used to protect the guide plate, chain,
clutch and sprocket during operation of the chain saw.
7.
Tensioning device
─ used to adjust the chain tension.
8.
Locking nut of right side plate
─ used to fix the right
side plate and fix and disassemble the guide plate of the
chain.
9.
Guide plate
─ used for supporting and guiding the saw
chain.
10.
Chain
─ used as a cutting tool.
11.
Fuel tank cover
─ used to seal the fuel container. Tighten
it by means of clockwise rotation.
12.
Oil tank cover
─ used to seal the oil tank. Tighten it by
means of clockwise rotation.
13.
Starter handle
─ refer to the handle of the starter, used to
start the engine.
14.
Stop switch
─ used to disconnect and connect the ignition
system to start and stop the engine.
15.
Starter cover
─ refer to an important component for
installation of the start-up system and a power-driven
intake channel.
16.
Trigger
─ activated by the finger and used to control the
engine speed.
17.
Trigger control arm
─ refer to a safety protection device.
The trigger cannot be activated until the trigger control
arm is pressed. The trigger control arm can be used to
prevent misoperation of the throttle controller.
18.
Choke valve pulling rod
─ used to adjust the mixing
ratio of fuel and air in the carburetor and assist the engine
start-up.
19.
Air filter locking nut
─ used to fix the small cap of the air
filter.
20.
Small cap of air filter
─ used to protect the air filter.
21.
Large cap
─ refer to the grids through which cooling air
flows. The large cap is used to protect the cylinder, spark
plug and muffler.
22.
Guide plate sleeve
─ refer to a protective device used
to cover the guide plate and chain when the chain saw is
relocated or not in use.
