8957102
14 in. Electric Wet/Dry Concrete Saw
V4.0
12
For technical questions call 1-800-665-8685
SWITCH ACTION
CAUTION: Before plugging in the
tool, always check to see that the
switch trigger actuates properly
and returns to the "OFF" position
when released
CAUTION: Switch can be locked in
"ON" position for ease of operator comfort during extended use. Apply caution
when locking tool in "ON" position and maintain firm grasp on tool.
To start the tool, simply pull the switch trigger. (A direction) Release the switch
trigger to stop.
For continuous operation, pull the switch trigger (A direction), push in the lock
lever (B direction) and then release the switch trigger.
To stop the tool from the locked position, pull the switch trigger (A direction)
fully, then release it.
CAUTION: Do not pull the switch trigger hard without pressing the lock lever.
This can cause switch breakage.
To prevent the switch trigger from accidentally pulled, a lock lever is provided.
To start the tool, push in the lock lever (in the B direction) and then pull the
switch trigger (in the A direction). Release the switch trigger to stop.
ASSEMBLY
CAUTION: Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
BLADE GUARD BRUSH
There is a removable brush at the rear of the guard to help contain sparks, dust,
debris and slurry. To install, simply push the brush into the slot in the bottom of
the dust port bracket until it clicks in place. This brush may be pulled straight
out to replace when worn.
SPLASH GUARD
The spring-loaded splash guard is useful to help to contain slurry which
splashes toward the back.
