V4.0
14 in. Electric Wet/Dry Concrete Saw
8957102
Visit www.princessauto.com for more information
11
INTRODUCTION
This machine is equipped with two handles and a blade guard. The motor has
overload and overheat protection. It has an integrated water feed system as
required for diamond cutting and has a portable residual current device (PRCD)
for electrical safety. It is used primarily with diamond blades, but abrasive
wheels may also be used with this machine. It is intended for cutting masonry,
stone, concrete, reinforced concrete and similar materials. All other uses are
prohibited.
FUNCTIONAL DESCRIPTION
CAUTION: Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
ADJUSTING THE DEPTH OF CUT
Loosen the wing bolt on the depth
guide and move the base up or down.
At the desired depth of cut, secure the
base by tightening the wing bolt.
Only case you adjust the cutting depth
to the maximum one, always be sure to
do the adjustment after adjustment of
the wheel guard.
SECURING WHEEL GUARD
CAUTION:The wheel guard must
be adjusted on the tool so that
the closed side of the guard
always points toward the
operator. The wheel guard can be
adjusted about 80 degrees, after
you loosen the clamping nut.
Adjust to the desired angle, then
secure the clamping nut.
