Air Hammer with 3 pc Chisels
14
For technical questions call: 1-800-665-8685
8435893
V 2.1
TROUBLE SHOOTING
If the tool does not function properly or if it is missing parts, contact Princess Auto Ltd. for a solution. If
unable to do so, have a qualified technician service the tool.
Problem(s)
Possible cause(s)
Suggested solution(s)
Tool runs at normal speed but
loses power under load.
Motor parts worn.
Have a qualified technician replace
worn parts.
Lack of air tool oil.
Pour air tool oil into air inlet
per instructions.
Tool runs slowly. Air flows
slightly from exhaust.
Motor parts jammed with
dirt particles.
OR
Air flow blocked by dirt.
Check air inlet filter for blockage.
Pour air tool oil into air inlet
as per instructions.
Operate tool in short bursts.
Disconnect air supply. Free motor by
rotating drive shank manually
where applicable.
Repeat above as needed. If this fails,
bring to Princess Auto Ltd. or to a
qualified technician.
Excessive air tool oil in tool.
Run tool under no load for short
periods of time until exhaust clears.
Buildup of shipping grease.
See Removing Packing Grease section.
Air Flow Regulator is in the
closed position
Open regulator to correct position
