Power Fist 9049107, Manual

Page: 8 / 32

7. Do not use the charger with an extension cord. This can cause a low
voltage outage during charging.
8. Do not charge leaking batteries. A compromised casing will release
volatile chemicals and gases. Charging a leaking battery can cause a fire
or explosion.
9. Do not operate the charger if it has received a sharp blow, been dropped
or otherwise damaged in any way. Have it serviced or replaced.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace
the missing part before operating. Failure to do so could result in a
malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Contents:
• Polisher • Terry cloth bonnet • Microfiber bonnet
IDENTIFICATION KEY
A. Power Switch
B. Handle
C. Foam Pad
D. Battery Pack (not included)
ASSEMBLY & INSTALLATION
INSTALL THE BONNET
1. Position the sanding drum so that it does not touch anything.
2. Before using the polisher on a workpiece, test the polisher by running it
at the highest speed rating for at least 30 seconds in a safe position. Stop
immediately if there is any abnormal vibration or wobbling. Check the tool
to determine the cause.
FIGURE 1.
9049107 LI-ION CORDLESS ORBITAL POLISHER V1.1
www.princessauto.com / 1-800-665-8685 Page 8