Power Fist 9049073, Manual

Page: 9 / 32

V1.0 Li-ion Cordless Heat Gun 9049073
Visit www.princessauto.com for more information 9
ASSEMBLY & INSTALLATION
INSTALL EXTERNAL BATTERY PACK
1. Check the battery power level before each use.
•
The battery is not fully charged out of the carton. Charge the battery
before first use.
2. Install the battery by aligning the rib on the battery with the groove on
the battery port and push forward until the latch clicks.
3. Remove the battery by pushing the battery lock button and pulling the
battery free.
OPERATION
The battery is not fully charged out of the carton. Charge the battery before
first use.
1.
Set the tool’s trigger switch to the OFF position before installing or removing
the battery. This will help prevent injuries due to accidental starts.
2. Check the battery power level before each use.
3.
Install the battery by aligning the rib on the battery with the groove on
the battery port and push forward until the latch clicks.
4. Remove the battery by pushing the battery lock button and pulling the
battery free.
5. To facilitate cooling of the battery pack after use, avoid placing the
charger or battery pack in a warm environment such as in a metal shed or
an uninsulated trailer.
BEFORE EACH USE
1. Clear the work area of combustible or flammable materials.
2. Make sure the work area is well ventilated as there may be toxic or irritating
fumes from the paint or coating being removed.
3. Clean the nozzle of any residue from previous work.
ATTACHING A NOZZLE
The heat gun provides a wide column of heat for general tasks. There are also two
additional nozzles included: the jet nozzle and the deflection nozzle.
1.
The jet nozzle forces the heated air through a narrow aperture to
isolate the area that is being heated. It is suitable for soldering or
loosening small electronic components (Fig. 2).
Figure 2