9039595
Air Engraving Pen
V1.0
4
For technical questions call 1-800-665-8685
4.
Check the manufacturer’s maximum pressure rating for air tools and accessories.
Compressor outlet pressure must be regulated to never exceed the maximum
pressure rating of the tool (see Specifications). Exceeding the maximum PSI rating
can create a bursting hazard, causing injury and property damage.
5.
Turn OFF the valve and discharge any remaining air pressure after each use or
before adjusting the tool.
POWER TOOL PRECAUTIONS
1.
Do not use any power tool with a malfunctioning power switch or control. A
power tool that fails to respond to the controls is dangerous and can cause an
injury. A qualified technician must repair and verify the power tool is operating
correctly before it can be used.
2.
Do not cover the air vents. Proper cooling is necessary prevent damage to the
tool’s motor.
3.
Disconnect the power source before installing or servicing the tool.
AIR HOSE PRECAUTIONS
1.
Inspect the tool's air hose for cracks, fraying or other faults before each use.
Discontinue use if the air hose is damaged or hissing is heard from the air hose or
couplers. Replace the defective air hose.
2.
Prevent damage to the air hose by observing the following:
a.
Never carry the tool by the air hose.
b.
Keep the air hose away from heat, oil, sharp edges or moving parts.
3.
A damaged or disconnected air hose under pressure may whip around and inflict
personal injury or damage the work area. Secure the compressor's air hose to a
fixed or permanent structure with clamps or cable ties.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the missing part
before operating. Failure to do so could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect for damage. Make
sure that all items in the contents are included.
Contents:
•
Engraving Pen
•
Whip Hose
IDENTIFICATION KEY
A
Needle Guide
B
Nose
C
Body
D
Throttle Valve
E
Needle
F
Whip Hose
G
Air Coupler