V1.0
Bench Grinder Pedestal Stand
9027905
Visit www.princessauto.com for more information
5
6. Place the fixed plate (#1) over the support pole. Secure it in place by
tightening its 2 set screws.
7.
Attach the plastic hanger (#10) to the fixed plate from underneath
using the small screw (#11). Ensure the washer is positioned between
the hanger and the plate.
8. It is strongly recommended that you mount the base to the floor using
3/8 in. bolts of a type compatible with the floor surface.
MOUNTING A GRINDER
1.
If the grinder (or other stationary power tool) has rubber feet, remove
them. This will allow the grinder to sit flat on the pedestal stand.
2. Place the grinder on top of the pedestal stand, aligning the mounting
holes of both the grinder and the pedestal stand. Ideally, the front of
the grinder should be square with the front of the mounting surface.
3. Secure the grinder with the hardware described in its owner's manual.
If the mounting hardware is not listed, use a hex bolt (#6) not
exceeding 7/16 in. in diameter, two flat washers (#9), a lock washer (#7)
and a hex nut (#8).
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Maintain the tool’s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd.
for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
