8990905
23 Gauge Pin Air Nailer
V1.0
10
For technical questions call 1-800-665-8685
Air leak
between body
and cylinder
cap
1. There are loose screws.
2. The O-rings or seals are
worn or damaged.
1. Tighten the screws.
2. Check and replace
the O-rings or
seals.
Blade driving
fastener too
deep
1. The bumper is worn.
2. The air pressure is too high.
1. Replace the
bumper.
2. Adjust the air
pressure.
Tool not
operating well:
cannot drive
fastener,
sluggish
operation
1. The air supply is inadequate.
2. The lubrication is
inadequate.
3. The O-rings or seals are
worn or damaged.
4. The exhaust port in the
cylinder head is blocked.
1. Verify that the air
supply is adequate.
2. Place 2 to 6 drops
of pneumatic tool oil
on the air inlet.
3. Check and replace
the O-rings or
seals.
4. Replace the
damaged internal
parts.
Tool skips
fasteners
1. There is a worn bumper or
damaged spring.
2. Dirt is lodged in front plate.
3. Dirt or damage is preventing
fasteners from moving freely
in magazine.
4. The cylinder cover seal is
leaking.
5. The O-ring on the piston is
worn, dry or needs
lubrication.
1. Replace the
bumper spring or
the pusher spring.
2. Clean the drive
channel on the front
plate.
3. Clean the
magazine.
4. Replace the
cylinder cover seal
washer.
5. Replace and/or
lubricate the O-ring.
