V4.0
1.45 GPM @ 1,600 PSI Electric Pressure Washer
8976904
Visit www.princessauto.com for more information
13
1. Replace the O-rings of any connection that leaks.
2. Replace the connectors if the leaks continue.
3. Tip the pressure washer onto its side to remove water from the pump
CLEANING
Use a damp cloth to wipe exterior surfaces clean. A soft bristle brush can
loosen caked on dirt, oil, etc. A vacuum cleaner will remove loose dirt and
debris in difficult to reach places.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility. Contact your
local municipality for a list of disposal facilities or by-laws for electronic
devices, batteries, oil or other toxic liquids.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Problem(s)
Possible Cause(s)
Suggested Solution(s)
No pressure or
Low pressure.
1.
Low water supply.
2.
Nozzle obstructed.
3.
Water filter screen
obstructed.
4.
Defective thermal
relief valve.
5.
Air in hose.
6.
High pressure hose
too long.
1.
Water supply must be 2.5 GPM
@ 40 to 60 PSI.
2.
Clean nozzle of debris.
3.
Remove and clean filter.
4.
Replace the thermal relief valve
or have a qualified technician
repair it.
5.
Stop the motor and water
source. Disconnect water
source from pump inlet and
turn water source to ON to
remove all air from hose. When
steady stream of water is
present, turn water source to
OFF. Re-connect water source to
pump inlet and turn on water
