8667834
10 Ton Hydraulic Porta-Power Autobody and Frame Repair Kit
V4.0
8
For technical questions call 1-800-665-8685
Flat Base
(H) – Install on the ram’s base to provide a broad surface to spread
the load during use. Attach using the male connector (M).
Duckbill Spreader
(F) – Fits into small spaces and forces the structure apart
when the jaws open. The spreader connects directly to the pump (B).
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List. Letter
references in parenthesis (A) refer to the included Identification Key.
RAM SET-UP
All accessories and adapters are friction fit, except the ram toe (I). Lubricate the
inside of the accessory with grease if it does not slide on until seated.
1. Screw the handle (#12) into the pump’s handle socket (#13).
2. Screw the hydraulic hose (B) onto the ram’s (C) inlet port until hand tight.
3. Slide an accessory onto the ram piston and push it down until fully seated.
4. Press the male connector (M) into the ram end, adding grease as
necessary. Press the flat base (H) or body toe (J) onto the male connector.
Fitting other accessories to the male connector is not recommended. The
ram needs a wide base to distribute the force applied at the other end of
the ram.
5. Add one or more extension tubes (D) between the accessory and the ram
piston or male connector to help fit the ram into a space or reduce the
distance the ram must travel.
a. When using two or more extension tubes together, arrange them with
the longest attached to the ram and the shortest as the final tube
attached to the accessory.
6. Screw the ram toe (I) onto the pump if using it to spread a workpiece.
Remove the plastic cap from the ram to expose the threads. Thread the
ram toe into place until it is tight. Place the body toe on the piston and
make sure it is aligned with the ram toe. Do not attempt to use this set-up
when the body toe is not aligned.
