V4.0
8 in. Variable Speed Bench Mount Buffer
8656860
Visit www.princessauto.com for more information
11
3. The buffing wheel should rotate into the object being buffed.
4. Adjust the buffer’s speed with the control knob (#24). See Specifications
for the RPM range.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Maintain the tool’s labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
6. Replacement wheels must have a minimum rated speed of 3,600 RPM and
a maximum diameter of 8 in.
7. The threads on the right side of the buffer (facing unit) are right hand;
threads on the left side are left hand. Hold the wheels firmly to loosen the
hex nut.
8. Make sure hex nuts are tight and snug against the outer wheel flange prior
to restarting buffer.
9. A guard or other part that is damaged should be properly repaired or
replaced. Do not perform makeshift repairs.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
LUBRICATION
This tool is permanently lubricated at the factory and requires no additional
lubrication.
STORAGE
When not in use for an extended period, apply a thin coat of lubricant to the
steel parts to avoid rust. Remove the lubricant before using the tool again.
