8656860
8 in. Variable Speed Bench Mount Buffer
V4.0
10
For technical questions call 1-800-665-8685
MOUNT BUFFER
PEDESTAL MOUNT
1. Align the mounting holes in the buffer with the pedestal holes.
2. Drop a 1/4-20 x 1-1/4 in. bolt into each mounting hole.
3. Slide a 1/4 in. washer onto one bolt from beneath the pedestal plate.
4. Place a 1/4-20 in. hex nut on the same bolt and tighten until there is only
1/8 in. space between the buffer base and the pedestal plate.
5. Repeat for the other three bolts.
6. Add another hex nut to each bolt and tighten to prevent them from
loosening due to vibration.
BENCH MOUNT
1. Position the buffer on the bench and mark each hole of the base on
the bench.
2. Predrill a hole for each wood screw if necessary.
3. Place a flat washer over a 1/4 x 1-1/4 in. wood screw.
4. Insert a wood screw and washer through the holes in the base.
5. Tighten the screws until the space between the buffer and bench is 1/8 in.
OPERATION
ON/OFF SWITCH WITH KEY
The ON/OFF rocker switch with key (#16) is located on the front of the buffer. Press
the switch up to turn the power ON. Push the switch down to turn the power OFF.
Remove the yellow key from the switch when you are finished working with the
buffer. The power switch will not work without the yellow safety key in place. The
safety key can only be removed when the power switch is in the OFF position.
BASIC BUFFER OPERATIONS
1. Keep a steady, moderate pressure on the work and keep it moving at an
even pace for smooth buffing.
2. Pressing too hard overheats the motor and prematurely wears down the
buffing wheels.
