V4.0
Combination Belt and Disc Sander
8532293
Visit www.princessauto.com for more information
11
3. Mount the sanding disc table (Fig. 6-2) on the sanding disc guard (Fig. 6-1).
4. On both sides of the sanding disc guard, there are two angular notches.
Push both hooks that are on the inner side of the table into these notches.
These two hooks are the centre of rotation for the table.
5. First, push the table horizontally
against the sanding disc plate and
then vertically upwards. To tighten
the sanding disc table, use both
yellow knob screws. Tighten the
knob screws (Fig. 7-2) into the
disc guard through both guide
slots that are situated on the table.
6. Position the sanding table to the
required angle to the sanding
disc plate and tighten the two
knob screws.
IMPORTANT! One accessory is a scale (Fig. 7-3). Whenever you intend to
make a double mitre section, use the scale. Adjust the required angle and
place the rod (Fig. 7-1) of the scale into the groove of the sanding disc.
OPERATION
The rocker ON/OFF power switch is located on the front of the sander.
1. Press the side marked ON to turn the sander on.
2. Press the side marked OFF to turn the sander off.
DUST COLLECTION SYSTEM
For dust collection, two adapters are provided with the belt and disc sander.
1. Use the dust collection whenever possible.
2. If no dust collection system or vacuum cleaner is available while sanding,
protect yourself by wearing a dust mask.
Fig. 7
