18V Cordless Drill
6
For technical questions call: 1-800-665-8685
8390270
V 2.0
OPERATION
PARTS IDENTIFICATION
BEFORE USE
If the machine is new, the battery must be charged. Battery is housed in the handle. Swing
over battery retaining clips and remove battery from handle. A new battery or one which has
not been used for an extended period achieves full performance only after approx. 5 hours
charging and discharging cycles. A substantial drop in operating period per change indicates
that the battery is worn out and must be replaced.
The power voltage supply must conform to that specified on the rating plate of the rapid charger. Always inspect
battery charger, cord and plug before use. Always have damage repaired by a qualified professional.
• Protect battery charger against humidity and operate only in dry areas.
• The supplied charger is suitable for charging batteries only.
CHARGING THE BATTERY
Start the charging process by plugging in the battery
charger and inserting the battery into the battery
charger slot. The battery and battery charger become
warm during the charging process. This is normal. After
termination of the charging (approx. 3-5h), pull charger
out of socket and remove battery.
To prevent incorrect battery insertion on the charger,
please insert the battery pack according to the position
of the girl to the charger as the figure.
Chuck ø
3/8 in. keyless
On/Off switch
Battery
Rotation direction
switch with lockout
Torque 16+1
Battery retaining clip