3/8 in. Reversible Composite Air Drill
10
For technical questions call: 1-800-665-8685
8344525
V 2.6
AIR COMPRESSOR
Ensure the compressor used with the tool can supply the required Cubic Feet per Minute at the required
PSI (see Specifications).
1. Use proper size and type of air pressure line
and fittings.
2. Use only clean, dry, regulated compressed air at the
rated range as marked on the tool.
CAUTION! Do not use an air source besides an air
compressor to power this tool.
3. Always use an air regulator, an in-line filter and
a moisture trap in your compressed air system.
These accessories will increase the tool’s life and
keeps the tool in good working condition.
See the
diagram for recommended components of an
air line.
4. Avoid using an air hose that is too long. The longer
the hose, the lower the pressure that reaches the tool, possibly causing it to cease functioning.
As well, a longer hose can become a tripping hazard.
5. Air tool CFM consumption ratings are based upon a 25% duty cycle. If you require continuous
duty, a larger compressor is required.
AIR SOURCE INSTALLATION
WARNING! Never use pure oxygen, carbon dioxide, combustible gases or any bottled gas as an air
source for a tool. Such gases are capable of causing an explosion and serious injury to persons.
1. Set the air pressure regulator on the air compressor to the recommended PSI level (see
Specifications). Do not exceed the tool recommended air pressure. Excess pressure could
result in damage to the tool, to your workpiece or serious injury.
2. Prepare a standard 1/4 in. air connector for use with your tool. Wrap the threaded portion of
the air connector with thread seal tape. Wrap in a clockwise direction so it will not unravel when
attaching to a quick connector. Attach it to the tool air inlet and tighten.
3. Attach a standard quick connector to the air source’s hose. Attach the air hose to the
tool’s air connector.
4. Check the air line and its connections for air leaks. Do not use the tool until you have repaired
all air leaks.