8. Always ensure that the slicer is safely set up or installed before you start to use it
9. The slicer should always be used with the sliding feed table and piece holder in position, unless
this is not possible due to the size or shape of the food. Do not use the slicer to slice through bones
or deep-frozen food.
10. Do not use the slicer if it is damaged in any way. Have the slicer immediately repaired at an
authorized service center or other suitably qualified repairer.
11. Use the slicer with the supplied accessories only.
12. No claims under the guarantee or liability for damages will be accepted if they result from improper
or incorrect use of the slicer.
13. The cutting blade continues to rotate after the slicer has been switched off, be sure it has stopped
moving completely before cleaning or adjusting.
14. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified person in order to avoid a hazard.
Before first use
Take the slicer carefully out of its packaging. Remove all the packaging material and keep it together
with the packaging. Clean the slicer before it comes into contact with any food (refer to the section
headed ’Cleaning’)
Setting up the slicer
1. Never set the slicer up on a hot surface or near an open flame.
2. Make sure that the electrical cord does not pass over hot or sharp –edged objects
3. Do not allow the cord to become kinked or trapped and do not wind it around the slicer.
• Set up the slicer on a flat, non-slip surface close to an electrical socket.
S
Slliic
ciin
ng
g
1. NEVER touch the blade when the slicer is operating! Injury will result!
2. Use the slicer only for slicing normal household foods and not other purposes. Do not use the slicer
for slicing deep-frozen foods, bones, foods with large kernels or for slicing packaged foods.
3. NEVER use the slicer for more than 10 minutes continuously.
4. The cutting blade(3) continues to rotate after the slicer has been switched off.
5. To prevent accidental injury, the slice thickness must be returned to the “0” setting after use.
Page 3