750 lb Flatbed Trailer
3
Visit www.princessauto.com for more information
8197220
V 2.9.1
SPECIFIC SAFETY PRECAUTIONS
1. This cart has a load capacity of 750 lb. Do not exceed the capacity. Be aware of dynamic loading: a sudden
load movement may exceed the capacity briefly, causing product failure.
2. This cart is designed for low speed. Do not operate over 8 km/h (5 MPH).
3. Be sure that the area is clear before operating.
4. If the cart strikes an object during operation, stop and inspect the cart. Repair if necessary before restarting.
5. Inspect before use; do not use if parts are damaged or broken. Check all bolts and nuts in the cart. Do not
use if damaged.
6. If towing cart up or down a slope, approach the slope directly. Driving across a slope significantly increases
the risk of overturning.
7. Be sure to read and understand all instructions and warnings set forth by the manufacturer of the vehicle
that the cart will be attached to.
8. Ensure the load is secure on the cart before transporting.
ASSEMBLY
NOTE: When this manual refers to a part number, it refers to the included Parts List section.
1. Locate and layout all parts as shown below.
2. With the bed upside down, attach the axle support plates (#4) to the frame (#9) using bolts (#3), lock
washers (#7) and nuts (#8). Only hand tighten at this time.
3. Attach the front support bracket (#10) to the bottom of frame using bolts (#12), lock washers (#13) and nuts
(#14). Only hand tighten at this time.
4. Lay the tongue (#1) into the support bracket and align with the axle support plates, as you thread the shaft
(#6) through the supports, spacers (#5 and #26), and tongue. Secure the tongue to the front support bracket
using the pin (#2).
5. Place the wheels (#18) onto the wheel spacers and secure with washers (#15) and cotter pins (#16).
6. Tighten all bolts and nuts from steps 2 to 5 securely.
7. Determine the type of hitch you wish to use:
a. For ball hitch, attach ball coupler (#27) using bolts (#28), lock nuts (#30) and flat washers (#29).
b. For clevis hitch, attach hitch plate (#22) using carriage bolts (#23), flat washers (#24) and lock nuts
(#25). Drop the hitch pin (#21) into the hitch holes and secure it with the presto pin (#11).
8. Tighten hardware from step 7 securely.
OPERATION
To dump the cart, remove pin (#2) and tilt bed. After dumping, re-insert pin and secure it with presto pin (#11).
MAINTENANCE
WARNING! Remove any load from the unit before performing any maintenance.
CAUTION! Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected
before further use.
1. Before each use, inspect the general condition of the cart. Check for misalignment, loose or damaged parts
and any other condition that may affect its safe operation.
2. Check all hardware for tightness before each use.
3. Lubricate bushings as needed. Oil or grease moving parts as required.
CAUTION! Only qualified service personnel should repair the unit.
