Power Fist 8186306, User Manual

Page: 11 / 36

3 GPM @ 3,200 PSI Gas Pressure Washer
11
Visit www.princessauto.com for more information
8186306 V 3.0
MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to control and will have
fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or worn components.
3. Follow instructions for lubricating and changing accessories.
4. Keep the tool handles clean, dry and free from oil/grease at all times.
5. Inspect the tool fittings, alignment and hoses and power supply cord periodically. Have damaged or worn
components repaired or replaced by an authorized technician.
6. Maintain the tool’s label and name plate. These carry important information. If unreadable or missing, contact
Princess Auto Ltd. for replacements.
CAUTION! Only qualified service personnel should repair the tool.
STORAGE
When placing the pressure washer into storage, follow this procedure:
1. Thoroughly clean the injector valve and clear hose (#7) with clean water.
2. With the motor still on, squeeze the trigger for 1 minute using clean water to clean the system
of contaminants.
3. Ensure the oil level in the pump reservoir is at the red dot in the middle of the sight glass. Do not over fill or
under fill pump oil.
4. Store inside or cover with a waterproof tarpaulin and tie it securely around the machine.
5. Do not allow children to play on or around the stored unit.
6. Flush both the water inlet and clear hose with clean water when starting to use again.
INSPECTION
Regular inspection is the key to preventing breakdowns and prolonging the life of the equipment.
CAUTION! Turn off motor, relieve internal water pressure and wait for all moving parts to stop before servicing,
adjusting or repairing.
1. Daily
a. Check that the nozzle on the spray wand is not clogged or worn.
b. Check pump oil level. The oil level should always be at the center of the sight glass.
c. Check engine oil level. It should be within the operating range on the dipstick.
d. Check that the water supply is adequate.
e. Check for loose hardware. Tighten if necessary.
f. Check fittings for water leaks. Tighten fittings and reapply thread tape where sealing is required.
2. Weekly
a. Check the pressure hose for wear and damage. If damaged, contact Princess Auto to have it replaced.
b. Check water inlet filter. Rinse the screen to remove any debris.
c. Check the engine’s air filter for dirt build up. Replace if necessary.
d. Check the engine’s fuel filter for dirt and sediment. Clean or replace if necessary.
3. Monthly
a. Replace oil after the first 50 hours of use. Replace oil every 500 hours of operation thereafter. Only use non-
detergent, SAE 20-30 weight oil designed for pressure washer pumps.
b. Replace the engine oil as recommended by the engine owner’s manual.