Quick lock / Release vise
The cut off saw is equipped with a quick lock / release vise system as
standard equipment. With this feature you are able to open and close the
vise quickly without repetitive turning of the vise crank handle.
Using the quick lock / release vise
To loosen :
1. Slightly release tension on the vise by rotating the crank handle counter
clockwise one half to 1 turn.
2. Lift up the quick lock / release lever and pull back on crank handle to
slide open the vise.
To tighten :
1. Push the crank handle forward to slide the vise against the work piece.
2. Push down on the quick lock / release lever to engage its threads with
vise screw.
3. Rotate the crank clockwise to tighten the vise against the work pieces.
Adjustable positive depth stop
The adjustable depth stop is threaded into the base of the saw at the rear.
By raising and lowering the depth stop bolt with a wrench you can
control how far the abrasive wheel travels when the saw handle is
depressed.
This feature is particularly useful :
a) To increase wheel travel as the abrasive wheel wears
b) To cinch up the saw's handle against the transport chain when moving
the saw or during storage,
c) To limit travel of the abrasive wheel
d) After installation of a new abrasive wheel.
8069627 manual 3/29/05 5:04 PM Page 8
