Attaching Sandpaper:
1
. Attach a piece of sandpaper to the sanding pad using the
hook and loop technology (as shown)
2
. Insert the battery
3
. Apply a little pressure to the power trigger and slowly
lower the sander to the workpiece.
Note:
there are holes in the sandpaper and sanding pad. this allow the sanded
particles and dust to be removed from the work surface. Occasionally lift the
sander from work surface to allow the accumulated dust to fall from the sanding
attachment.
Reciprocating Saw Attachment
Follow the steps 1-8 (changing attachments) from
above to install the Reciprocating Saw
attachment. You can only operate the
Reciprocating Saw in the forward direction. The
direction control defaults to this position once the
Reciprocating Saw attachment is attached.
Prior to use:
• Make sure the Reciprocating Saw attachment is properly attached and secure.
• Make sure the direction switch is in the locked (middle) position and not the
reverse position.
Note:
this will damage the power tool.
• Remove battery before changing blades or the attachment.
Warning: Never operate the Reciprocating Saw attachment
without using ANSI or CSA approved eye protection glasses.
Direction Control: > Forward Only
Attaching Blade:
Red blade: has smaller teeth and is used on harder material
such as metal
White blade: Has larger teeth and is used on softer materials
such as wood.
1.
Locate the blade chamber inside the reciprocating saw
attachment.
2.
Hold the attachment with the chamber facing you. the
opening for the hex key should be on the left side of the
attachment.
3.
Insert the hex key into the screw opening on the left side of the
attachment and turn counter clockwise to loosen the chamber.
Sanding
Pad
Sandpaper
Saw blade
Guide
Blade
Chamber
Saw head
Hex Key
Opening
Inserting blade
Tightening blade