12
4.8 ASSEMBLY FOR ITEM 8093270 (ref. pages 42-43)
1. Install rubber feet (6) to rear leg (5) using nuts (7).
2. Install rear leg (5) to base (1) using bolts (8) and nuts (7).
3. Place axle (13) through holes on base (1). Place spacers (14) on axle on either side of the base.
Place wheels (45) on the axle so the spacers are snug against the flanges of the base. Center the
axle so an equal amount of threads are exposed from the hub of each wheel.
4. Install washers (39) and lock nuts (40) on the threaded ends of the axle. Note that the axle has right
hand threads on both ends. Using a 1-1/16 wrench on each end, as one nut is tightened the opposite
will tighten. Tighten the nuts enough so the washers are flush with the bearing/hub (i.e. do not rattle),
but avoid over-tightening as the washer will press against the bearing and prevent the wheel from
turning. The lock nuts will be close to their proper installed position once the ends of the axle threads
become flush with the top face of the lock nuts.
If it is necessary to remove the wheels, loosen one nut - holding the opposite nut with a wrench. Once
the nut is off, use a pair of vice-grips to lock the axle (place grips somewhere along the middle of the
axle underneath the base, and avoid gouging the metal) and then remove the opposite nut. An
alternative is to remove the axle from the base once the nut is off and use a vice to take off the
remaining wheel.
5. Install front frame (4) to base (1) using bolts (10), washers (9) and nuts (24).
6. Install jug holder (12) to base (1) using bolts (8) and nuts (7).
7. Install rear handle assembly (3) to base (1) using bolts (10), washers (9) and nuts (24).
8. Install rubber grommets (16) to rear handle assembly (3).
9. Install quick-change nozzles (17, 18, 19) to rubber grommets (16).
10. Install pump/engine assembly to base (1) using bolts (15) and nuts (7).
11. Install male quick coupler (25) to the spray gun (11).
12. Install lance (22) to spray gun (11).
13. Install quick-change nozzle (23) to lance (22).
14. Install female quick-coupler (26) to hose (27).
15. Connect hose (27) to spray gun (11).
16. Install coupler (43) to free-end of hose (27).
17. Connect hose/coupler (27/43) to the discharge end of the pump (47).
18. If you are using detergent:
a) Attach clear hose (41) to chemical injector on pump (47).
b) Install strainer (42) at free end of clear hose (41).
c) Insert strainer end into detergent container (not supplied).